* If the ASWC has been in a vehicle before:
2) Press and hold the reset button down for more then 10 seconds.
3) After the 10 seconds the led will begin a slow constant flash.
4) At this point release the reset button, Press and hold the Volume Up button on the steering wheel
for 7 seconds until the led goes solid red. Now release the Volume Up
button and the led goes off. Volume Up has now been programmed.
5) Now press and hold the Volume Down button until the led goes solid red.
Release the Volume Down button and the led goes off. Volume Down
has now been programmed.
6) At this point press and hold the next button on the steering wheel that
corresponds with the programming list (see below). The chart below
shows in what order the steering wheel control buttons need to be
programmed in.
If the next function on the list is not on the steering wheel press and hold
the Volume Up button for 1 second till the led comes on then release the
button. This tells the ASWC that the function is not available and moves on
to the next function.
1. Volume Up
2. Volume Down
3. Seek Up/Next
4. Seek Down/Prev
5. Source/Mode
6. Mute
7. Preset Up
8. Preset Down
9. Power
10. Band
11. Play/Enter
12. PTT (Push To Talk)
13. On Hook
14. Off Hook
15. Fan Up
16. Fan Down
17. Temp Up
18. Temp Down
* Note: Remember not all radios will have all these commands. Please
refer to the radios’ owners manual for specific commands recognized by
the radio.

7) You can end this half of the programming in 2 ways:
        (1) After the last button on your steering wheel has been
programmed (you do not have to go through the whole list) hold
down the “Volume Up” button for at least
10 seconds. The LED will go into a slow constant blink mode.

8) Press and hold the “Volume Down” button for 5 seconds till the
LED starts to flash quickly.
9) Release the “Volume Down” button.
10) After 4 seconds of the LED flashing quickly the LED will go out
for 2 seconds.
11) Then the LED will flash, up to 11 times, depending on what radio
the ASWC-1 thinks it’s connected to.
12) Press and hold down the Volume Down button until the LED
goes solid.
13) Programming for the vehicle and the radio is now complete.
Next, test the steering wheel control functions to make sure it
works correctly.